Real 300-610 dumps Accurate Questions and Answers with Free and Fast Updates
Real 300-610 Quesions Pass Certification Exams Easily
NEW QUESTION # 18
What influences the number of ISLs that are required between Cisco MDS Series switches?
- A. N Port virtualization
- B. end-to-end oversubscription ratio
- C. type of storage
- D. FCoE protocol
Answer: B
Explanation:
Section: Storage Network Design
Explanation/Reference: https://www.cisco.com/c/en/us/products/collateral/storage-networking/mds-9700-series-multilayer- directors/white-paper-c11-729697.html
NEW QUESTION # 19
Which two automation requirements can be met by using Puppet? (Choose two.)
- A. Enable one-off infrastructure changes to be performed manually.
- B. Push configuration updates immediately to servers.
- C. Provide support for writing new modules in Python.
- D. Enable clients to pull changes without installing an agent.
- E. Enable clients to pull changes to configuration files.
Answer: B,E
Explanation:
Section: Automation Design
Explanation/Reference: https://www.cisco.com/c/dam/en/us/products/collateral/servers-unified-computing/ucs-c-series- rack-servers/whitepaper_c11-740103.pdf
NEW QUESTION # 20
Which two features are provided by deploying an OOB management network in a Cisco Nexus data center?
(Choose two.)
- A. Layer 3 path for server traffic
- B. Layer 3 path for monitoring purposes
- C. Layer 2 path for server traffic
- D. Layer 2 path for a vPC peer link
- E. Layer 3 path for vPC keepalive packets
Answer: C,D
NEW QUESTION # 21
Refer to the exhibit.
The FCoE packets fail to be forwarded through the switch. What is the minimum MTU QoS requirement for the FCoE to work?
- A. 2158 bytes
- B. 2240 bytes
- C. 2000 bytes
- D. 9000 bytes
Answer: A
Explanation:
This policy map shows a wrong MTU config. Check "12. Do I need to enable Jumbo frames for FCOE?" in https://community.cisco.com/t5/data-center-documents/fibre-channel-over-ethernet-fcoe-questions-and-answers-from-live/ta-p/3108755
https://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus5000/sw/qos/521_n1_1/b_5k_QoS_Config_521N11/b_5k_QoS_Config_521N11_chapter_0110.html
NEW QUESTION # 22
Refer to the exhibit.
The FCoE packets fail to be forwarded through the switch. What is the minimum MTU QoS requirement for the FCoE to work?
- A. 2158 bytes
- B. 2240 bytes
- C. 2000 bytes
- D. 9000 bytes
Answer: C
NEW QUESTION # 23
Refer to the exhibit.
An engineer must assign multiple Fibre Channel IDs to a single port channel. Which two features must be enabled this goal? (Choose two.)
- A. NPV feature on the Cisco MDS Series.
- B. Smart Zoning feature on the Cisco UCS Fabric Interconnects
- C. end-host mode feature on the Cisco UCS Fabric Interconnects
- D. SAN Pin Groups on the Cisco UCS Fabric Interconnects.
- E. NPIV feature on the Cisco MDS Series
Answer: A,E
NEW QUESTION # 24
A network engineer is implementing Cisco UCS manager with Cisco UCS center integration. The company is strict security policies require that the logical profile of virtual network adapters and logical addressing assigned to Cisco UCS servers be managed by the Cisco UCS manager. The users must also be prevented from being able to acknowledge pending activities in the Cisco UCS manager. Which two profile must be used to meet these requirements? (Choose two.)
- A. Restricted chassis
- B. Public network control
- C. Local power
- D. Global maintenance
- E. Local service
Answer: D,E
Explanation:
Reference:
https://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/ucs-central/GUI-User-Guides/Operations/b_UCSC_Ops_Guide/b_UCSC_Ops_Guide_chapter_0111.html#id_16185
NEW QUESTION # 25
Drag and drop the components from the left onto the descriptions on the right that indicate what occurs to Fibre Channel fabric when that component fails.
Answer:
Explanation:
NEW QUESTION # 26
An engineer is designing a Multichassis EtherChannel topology in which two switches must appear as a single device to a third downstream switch? Which two technologies meet this requirement? (Choose two.)
- A. VSS
- B. vPC
- C. 802.1q
- D. FEX
- E. HSRP
Answer: A,B
NEW QUESTION # 27
Drag and drop the SAN components from the left onto the correct design considerations on the right.
Answer:
Explanation:
NEW QUESTION # 28
Refer to the exhibit.
A Cisco UCS chassis that has two IOMs is discovered. The chassis discovery policy creates a fabric port channel. What is the result of this policy?
- A. Cisco UCS Manager creates a single fabric port channel.
- B. Each uplink that connects an IOM is configured as a discrete link.
- C. The port channel is disabled until an administrator enables it manually.
- D. Cisco UCS Manager creates two separate fabric port channels.
Answer: D
NEW QUESTION # 29
An engineer requires a solution that achieves Ethernet traffic forwarding on all available paths from the hosts to the Cisco Nexus Fabric Extender and from the Fabric Extenders to the Cisco Nexus 5000 Series Switches. The NIC teaming from the Fabric Extender to a server should use an LACP EtherChannel. Which solution should be implemented to meet these requirements?
- A. Virtual Port Channel
- B. Back-to-Back Virtual Port Channel
- C. Enhanced Virtual Port Channel
- D. Virtual Port Channel Plus (vPC+)
Answer: C
NEW QUESTION # 30
A network engineer designs a Cisco Nexus data center network for a client-server farm using a pair of Nexus 9000 Series. Switches In a vPC setup. Each server connects with two interfaces to both Nexus switches. The Nexus switches must always initiate the negotiation with the server. Which feature should be used in this design to ensure traffic is forwarded from the server to the data center network?
- A. PAgp mode auto
- B. LACP mode active
- C. PAgP mode desirable
- D. LACP mode auto
Answer: B
NEW QUESTION # 31
Refer to the exhibit.
An engineer must assign multiple Fibre Channel IDs to a single port channel. Which two features must be enabled this goal? (Choose two.)
- A. NPV feature on the Cisco MDS Series.
- B. Smart Zoning feature on the Cisco UCS Fabric Interconnects
- C. end-host mode feature on the Cisco UCS Fabric Interconnects
- D. SAN Pin Groups on the Cisco UCS Fabric Interconnects.
- E. NPIV feature on the Cisco MDS Series
Answer: A,E
NEW QUESTION # 32
A network consultant reviews the requirements for the Storage Area Network (SAN) design. The proposed solution must offer a very efficient port usage and eliminate the need for a separate physical layer of switches and their associated ISLs. The design is not expected to require future expansion.
Which SAN topology must be used to meet these requirements?
- A. core-edge
- B. edge-core-edge
- C. collapsed-core
- D. core-distribution-access
Answer: A
NEW QUESTION # 33
An engineer must design Layer 2 connectivity for a subnet between two data centers. The engineer must ensure seamless host mobility and optimal first-hop routing. Which attribute must be synchronized across all data centers to achieve this goal?
- A. NX-OS version
- B. multicast group
- C. DCNM to manage both fabrics
- D. anycast gateway MAC
Answer: D
NEW QUESTION # 34
Which factor determines the choice of platform designing a Cisco HyperFlex infrastructure to support computer-aided design applications?
- A. GPU support
- B. network speed
- C. processor count
- D. storage capacity
Answer: A
Explanation:
https://www.cisco.com/c/dam/en/us/products/collateral/hyperconverged-infrastructure/hyperflex-hx-series/whitepaper-c11-740243.pdf
https://www.cisco.com/c/dam/en/us/products/collateral/hyperconverged-infrastructure/hyperflex-hx-series/hx-220c-m5-specsheet.pdf
NEW QUESTION # 35
A customer needs a design for a new network VLANs must be dynamically provisioned based on the information received from connected hosts No Layer 2 or Layer 3 configuration must be performed on the related switch ports. Which feature must be used?
- A. VM Tracker
- B. iPXE
- C. Network PnP
- D. POAP
Answer: D
NEW QUESTION # 36
Drag and drop the Cisco Nexus 7000 Series Switch resources from the left onto the correct groups on the right.
Answer:
Explanation:
NEW QUESTION # 37
A set of virtual machines must be live migrated from a data center to a disaster recovery site. The data center and disaster recovery sites are connected through an Inter-Pod Network topology. The gateway address of the virtual machine is the same across the data center and disaster recovery. Which Cisco Nexus feature supports this requirement?
- A. VXLAN EVPN
- B. FabricPath
- C. VPLS
- D. FHRR
Answer: A
NEW QUESTION # 38
A failure occurs on the network between two BFD and OSPF neighbors. Drag and drop the protocol actions from the left into the correct order on the right.
Answer:
Explanation:
NEW QUESTION # 39
A company has several data centers with hundreds of Cisco UCS blade chassis. A network consultant plans to active Cisco Discovery Protocol to the servers to facilitate Layer 1 troubleshooting. For security reasons, the company wants to restrict the servers from sending different MAC addresses to the fabric interconnect after the MAC address from the first packet is learned. Which two policies be modified to support this design? (Choose two.)
- A. Ethernet Adapter
- B. Pin Group Policy
- C. vNIC Policy
- D. Network Control Policy
- E. vNIC Template Policy
Answer: D,E
Explanation:
https://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/ucs-manager/GUI-User-Guides/Network-Mgmt/4-0/b_UCSM_Network_Mgmt_Guide_4_0/b_UCSM_Network_Mgmt_Guide_4_0_chapter_01010.html
https://jeremywaldrop.wordpress.com/2010/05/03/how-to-enable-cdp-on-cisco-ucs-vnics/
NEW QUESTION # 40
Refer to the exhibit.
Which template is used when a vHBA template pair is created for a specific server that inherits its attributes from an existing template?
- A. Updating
- B. Initial
- C. Secondary
- D. Primary
Answer: B
NEW QUESTION # 41
Which two methods mitigate congestion in a SAN network? (Choose two.)
- A. Configure the port channel to enable individual buffer-to-buffer credits.
- B. Use the port-monitor command to detect slow drain devices.
- C. Configure the flow control for the FC to use R_RDY.
- D. Configure ER_RDY to allow splitting of each ISL between switches into separate virtual links.
- E. Configure the port monitor to allow categorization of a specific device as slow.
Answer: B,E
NEW QUESTION # 42
What can be implemented on Cisco Nexus 5600 Series Switches for link redundancy within a Fibre Channel fabric?
- A. LACP port channel
- B. SAN port channel
- C. E-Trunk
- D. vPC+
Answer: A
Explanation:
Section: Compute Design
NEW QUESTION # 43
......
300-610 Dumps are Available for Instant Access: https://www.pass4leader.com/Cisco/300-610-exam.html
Practice with these 300-610 dumps Certification Sample Questions: https://drive.google.com/open?id=1tan6cUtNI_3WwqeiRmORsKPRzdhsS2kE