Get Latest [Sep-2021] Conduct effective penetration tests using Pass4Leader 300-610
Penetration testers simulate 300-610 exam PDF
NEW QUESTION 63
Drag and drop the components from the left onto the descriptions on the right that indicate what occurs to Fibre Channel fabric when that component fails.
Answer:
Explanation:
NEW QUESTION 64
Refer to the exhibit.
Which template is used when a vHBA template pair is created for a specific server that inherits its attributes from an existing template?
- A. Initial
- B. Primary
- C. Secondary
- D. Updating
Answer: A
NEW QUESTION 65
Which two configuration methods can be used to deploy QoS to Cisco MDS Series switches? (Choose two.)
- A. multiple QoS policies that match individual devices
- B. FCoE VLAN-based QoS
- C. VSAN-based QoS
- D. multiple QoS policies that match multiple devices
- E. zone-based QoS
Answer: C,E
Explanation:
Section: Storage Network Design
Explanation/Reference: https://www.cisco.com/c/en/us/td/docs/switches/datacenter/mds9000/sw/7_3/configuration/qos/ cisco_mds9000_qos_config_guide/configuring_qos.html
NEW QUESTION 66
Drag the requirements from the left onto the correct policy types on the right.
Answer:
Explanation:
NEW QUESTION 67
Refer to the exhibit.
Which template is used when a vHBA template pair is created for a specific server that inherits its attributes from an existing template?
- A. Initial
- B. Primary
- C. Secondary
- D. Updating
Answer: A
NEW QUESTION 68
Drag and drop the feature descriptions from the left onto the correct UCS Fabric Interconnect modes on the right.
Answer:
Explanation:
NEW QUESTION 69
An engineer must interconnect two geographically separated data centers. The service provider offers a Layer 2 Metro Ethernet link. The strict security policy requires that the information that is shared between two sites must be sent encrypted. The application deployed between two sites requires a line-rate throughput regardless of the packet size and speed.
Which solution meets these requirements?
- A. MACsec
- B. L2TPv3
- C. L2TPv2
- D. IPsec
Answer: A
NEW QUESTION 70
Drag the appropriate from the left onto the current UDLD modes of operation on the right.
Answer:
Explanation:
NEW QUESTION 71
An engineer is expanding an existing ISCSI environment and must choose an addressing scheme. When checking one of the devices, the engineer discovers this target device naming used
{prefix}. 2019-01.com.acme.123:00. ftd0cb21.bcb389458389
Which addressing scheme was used in the environment?
- A. ISCSI Qualified Name
- B. Extended Unique identifier
- C. Fibre Channel ID
- D. Network Address Authority
Answer: A
NEW QUESTION 72
Which mode must be enabled on a Cisco UCS Fabric Interconnect to connect directly to a storage array?
- A. NPIV mode
- B. FC end-host mode
- C. NPV mode
- D. FC switching mode
Answer: D
Explanation:
Section: Storage Network Design
Explanation/Reference: https://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/ucs-manager/GUI-User-Guides/ Storage-Mgmt/3-1/b_UCSM_GUI_Storage_Management_Guide_3_1/ b_UCSM_GUI_Storage_Management_Guide_3_1_chapter_01110.html
NEW QUESTION 73
Refer to the exhibit.
A high-availability setup for iSCSI is designed with the host running ISCSI software. Each storage port on the MDS exports the same two Fibre Channel target ports with different ISCSI target names. In this design, how many ISCSI session are created from the host so that recovery occurs if any component fails?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: C
Explanation:
https://www.cisco.com/en/US/docs/storage/san_switches/mds9000/sw/rel_3_x/configuration/guides/fm_3_2/ciscsi.html
NEW QUESTION 74
Which feature must be configured to connect a classical Ethernet network to a data center network so that the data center network appears to be one large switch.
- A. VPC+
- B. UDLD
- C. EVPN
- D. OSPF
Answer: C
Explanation:
Section: Network Design
NEW QUESTION 75
A network engineer must design a Cisco HyperFlex solution based on these requirements:
* two clusters in the main data center consisting of five HyperFlex nodes
* one edge node for the remote branch
* cluster nodes that use one rack unit of space
Which two devices should be used in the remote branch cluster for this design? (Choose two.)
- A. Gigabit Ethernet Switch
- B. HX220C
- C. Fabric Interconnect 6300
- D. HX240C
- E. UCSB B200
Answer: A,B
NEW QUESTION 76
Drag the appropriate from the left onto the current UDLD modes of operation on the right.
Answer:
Explanation:
NEW QUESTION 77
Drag and drop the technologies from the left onto the correct descriptions on the right.
Answer:
Explanation:
NEW QUESTION 78
The end users report issues with datastore reachability between the newly installed virtual machines (VMs) and the storage array. The VMs are deployed on a Cisco C-Series server, directly connected with Cisco Nexus 5672UP switches over FCoE VLAN. The data traffic on VLAN 99, which is designated as a native VLAN, reaches its default gateway, but FCoE VLAN 99 fails to access the datastore. Which action resolves the problem?
- A. Implement FCoE traffic on VLAN 10 and data traffic on VLAN 99.
- B. Configure the FCoE VLAN in the VSAN database before including it in the trunk port.
- C. Implement host-facing FCoE ports as spanning-tree port type edge.
- D. Configure the FCoE VLAN traffic on a separate interface from any other VLANs that traverse the network.
Answer: A
NEW QUESTION 79
Drag and drop the data center technologies from the left onto the correct descriptions on the right. Not all technologies are used.
Answer:
Explanation:
NEW QUESTION 80
An engineer finishes the initial set up of a VXLAN EVPN network. The engineer is asked to plan for connectivity that supports redundancy and extends multiple virtual routing and forwarding domains. The requirement is to use the same default gateway addressing across all leaf switches that belong to the VXLAN network. Which two solution must be used to meet these requirements? (Choose two)
- A. Distributed anycast gateway
- B. Inter-site network
- C. VRF-lite
- D. spanning tree protocol
- E. DC interconnect
Answer: A,E
Explanation:
Reference:
https://www.cisco.com/c/en/us/products/collateral/switches/nexus-9000-series-switches/white-paper-c11-739942.html
NEW QUESTION 81
Refer to the exhibit.
A cloud service provider deployed three geographically separated Cisco ACI data centers. One of the customers needs to host a clustered application that is spread across the three data centers. The cluster nodes that host the application need a Layer 2 topology to communicate with each other.
Which Cisco ACI topology design meets these requirements?
- A. Multi-Pod over MP-BGP EVPN
- B. Multi-Site
- C. Multi-Pod over OSPF EVPN
- D. Multi-Cloud
Answer: A
NEW QUESTION 82
What are two advantages of using Cisco vPC over traditional access layer designs? (Choose two.)
- A. supports Layer 3 port channels
- B. maintains single control plane
- C. disables spanning-tree
- D. no spanning-tree blocked ports
- E. uses all available uplink bandwidth
Answer: D,E
NEW QUESTION 83
Refer to the exhibit.
A Cisco UCS chassis that has two IOMs is discovered. The chassis discovery policy creates a fabric port channel. What is the result of this policy?
- A. Each uplink that connects an IOM is configured as a discrete link.
- B. Cisco UCS Manager creates a single fabric port channel.
- C. The port channel is disabled until an administrator enables it manually.
- D. Cisco UCS Manager creates two separate fabric port channels.
Answer: D
NEW QUESTION 84
An engineer manages hundreds of Cisco Nexus Series and 9000 Series Switches that are installed at several data centers and wants to use one of the built-in automation tools of the Cisco NX-OS Guest Shell to automate daily activities. The engineer requires a tool that uses imperative language, has extensive support, and is object-oriented. Which automation tool should be used to meet these requirements?
- A. YAML
- B. Perl
- C. Phython
- D. Bash
Answer: C
Explanation:
Python is object-oriented and imperative language.
YAML is declarative.
NEW QUESTION 85
A customer needs to deploy a three-tier network architecture that will consist of web, app, and other businesscritical applications. The solution will include Cisco UCS 6324 Fabric Interconnects managing B and C series servers. The fabric interconnects will be connected to the Cisco Nexus 7706 Series Switch for network access.
A storage array will be directly connected to the UCS fabric interconnects.
Which UCS deployment type must be used to meet these requirements?
- A. UCS interconnect in Ethernet end-host mode
UCS interconnect in Fibre Channel switching mode
Fabric Interconnects uplinked to the Nexus device using an LACP port-channel in active mode - B. UCS interconnect in Ethernet switching mode
UCS interconnect in Fibre Channel end-host mode
Fabric Interconnects uplinked to the Nexus device using an LACP port-channel in active mode - C. UCS interconnect in Ethernet switching mode
UCS interconnect in Fibre Channel switching mode
Fabric Interconnects uplinked to the Nexus device using an LACP port-channel in passive mode - D. UCS interconnect in Ethernet end-host mode
UCS interconnect in Fibre Channel end-host mode
Fabric Interconnects uplinked to the Nexus device using an LACP port-channel in passive mode
Answer: B
NEW QUESTION 86
Which type fields can an engineer use to identify an iSCSI participant? (Choose two.)
- A. port number
- B. type
- C. preshared key
- D. hostname
- E. identifying tag
Answer: A,D
NEW QUESTION 87
......
Tested Material Used To 300-610 Test Engine: https://www.pass4leader.com/Cisco/300-610-exam.html
Steps Necessary To Pass The 300-610 Exam: https://drive.google.com/open?id=18v3oN3jhQrfWvftmc0sAAzXInxEClSaD