Free Extreme Networks EW0-200 Practice Test & Real Exam Questions
Which of the following CLI commands would you use to enable ECMP for RIP?
Correct Answer: A
Vote an answer
If an asterisk (*) appears in front of the ExtremeWare command-line prompt, what does it indicate?
Correct Answer: D
Vote an answer
What is the default area type for all OSPF areas created using the ExtremeWare CLI create ospf area <area identifier>?
Correct Answer: A
Vote an answer
ExtremeWare can automatically upload the active configuration to an FTP server.
Correct Answer: B
Vote an answer
Prior to downloading a new software image to an Extreme switch using the network, you are required to place the software image in a file on a TFTP server that is accessible on the network.
Correct Answer: A
Vote an answer
When RIP is enabled in ExtremeWare, which RIP settings are than also enabled?
Correct Answer: C
Vote an answer
An Ethernet port cannot be added to two VLANs as an untagged port, with the following exception
Correct Answer: A
Vote an answer
The modular BlackDiamond 6804 switch supports the following legacy WAN modules? (Choose all three that apply)
Correct Answer: A,C,D
Vote an answer
What is the result when the CLI command disable stpd port 4 1-4 8 is entered,?
Correct Answer: D
Vote an answer
Which CLI command would you use to configure proxy ARP for IP address 10.0.0.1/24 with MAC address 00 11 22 33 44 55 so that it will respond regardless of the VLAN?
Correct Answer: B
Vote an answer
Which step would you take to configure a VLAN to only allow IP-related traffic?
Correct Answer: A
Vote an answer
