Free CWNP CWDP-304 Practice Test & Real Exam Questions

As a device starts to shift to lower PHY rates, what factors usually influence a device decision to shift to lower PHY rates?(Choose all that apply.)

You are validating association capabilities from clients to an 802.1X/EAP secure SSID. The RADIUS server's IP address is 10.100.50.25 and the default RADIUS authentication port is used. When testing them, none of the clients are able to associate to the SSID. Troubleshooting the WLAN infrastructure, you found out that the server is up and the RADIUS service is up as well, but the authenticator is not able to communicate properly with the server. What's your next troubleshooting step?

In the enterprise, when is WPA/WPA2-Personal generally a recommended solution?(Choose all that apply.) Response:

SSID hiding is not generally recommended because some frames require inclusion of the SSID. In what frames is the SSID always included?
Response:

Why does a frame transmitted at 1 Mbps have a greater usable range than the same frame transmitted at 54 Mbps?

Which document provided to your customer should include all devices and parts that are going to be used during the deployment of their WLAN infrastructure?

When installing APs on high ceilings, what should be the most common PPE to be used?

Which one of the following might be detected as a source of CCI during a post-validation survey in the 5 GHz band?

When performing a roaming test and packet capture at the same time, what are two particular frames that will be present when roaming between two APs is successful?

You must perform a site survey that defines signal strength, throughput and latency What kind of survey should you perform?