[Q30-Q47] Excellent 350-801 PDF Dumps With 100% Pass4Leader Exam Passing Guaranted [Sep-2021]

Share

Excellent 350-801 PDF Dumps With 100% Pass4Leader Exam Passing Guaranted [Sep-2021]

100% Pass Your 350-801 Implementing and Operating Cisco Collaboration Core Technologies at First Attempt with Pass4Leader

NEW QUESTION 30
Which program is required to deploy the Cisco Jabbar client on an on-premises Cisco collaboration solution?

  • A. Cisco Expressway-C
  • B. Cisco Unity Connection
  • C. Cisco UCM IM and Presence
  • D. Cisco UCM

Answer: D

 

NEW QUESTION 31
Refer to the exhibit.

This INVITE is sent to an endpoint that only supports G.729. what must be done for this call to succeed?

  • A. Noting; both sides support G.729.
  • B. Add a transcoder that supports G.711ualw and G.729.
  • C. ADD a media termination point that supports G.711ulaw and G.729.
  • D. Nothing; both sides support payload type.101.

Answer: B

 

NEW QUESTION 32
Which attribute contains an XMPP stanza?

  • A. type
  • B. presence
  • C. message
  • D. iq

Answer: A

Explanation:
Section: Collaboration Applications
Explanation/Reference: https://www.ciscolive.com/c/dam/r/ciscolive/apjc/docs/2011/pdf/TECUCC-2611.pdf slide 18

 

NEW QUESTION 33

Refer to the exhibit. An engineer configures a VoIP dial peer on a Cisco gateway. Which codec is used?

  • A. G.711ulaw
  • B. No codec is used (missing codec command).
  • C. G.711alaw
  • D. G.729r8

Answer: A

Explanation:
Section: Cisco IOS XE Gateway and Media Resources
Explanation/Reference: https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/voice/dialpeer/configuration/15-mt/vd-15-mt- book/vd-dp-cfg-examp.pdf

 

NEW QUESTION 34
According to the QoS Baseline Model, drag and drop the applications form the left onto the correct per-Hop Behavior values on the right.

Answer:

Explanation:

Explanation
Voice = EF
Interactive Video = AF41
Bulk Data = AF11
Call-Signaling = AF31/CS3
Network Management = CS2
https://www.cisco.com/c/en/us/td/docs/solutions/Enterprise/WAN_and_MAN/QoS_SRND/QoS-SRND-Book/Qo

 

NEW QUESTION 35
Refer to the exhibit.

Calls to Cisco Unity Connection are failing across Cisco Unified Border Element when callers try to select a menu prompt. Why is this happening and how is it fixed?

  • A. Cisco Unified Border Element is sending the incorrect media IP address. The IP address of the loopback interface must be advertised in the SDP.
  • B. The Cisco Unity Connection Call Handler is configured for a -Release to Switch" transfer type. Transfers must be disabled for the Cisco Unity Connection Call Handler.
  • C. Cisco Unified Border Element is not sending any support for DTMF. DTMF configuration must be added to the appropriate dial peer.
  • D. Cisco Unity Connection is configured on G.729 only. Cisco Unity Connection must be reconfigured to support iLBC.

Answer: C

 

NEW QUESTION 36
An incoming off-net call to a user fails. An engineer notices that the off-net call is G.711, but the phone accepts only G.729. Which media resource on a Cisco Unified Border Element and Cisco Unified Communications Manager must the engineer configure to manage the codec negotiation?

  • A. MTP
  • B. CFB
  • C. MOH
  • D. transcoder

Answer: D

Explanation:
Section: Infrastructure and Design

 

NEW QUESTION 37
What are two functions of Cisco Expressway in the Collaboration Edge? (Choose two)

  • A. Expressway-E provides a perimeter network that separates the enterprise network from the Internet.
  • B. Expressway-C provides encryption for Mobile and Remote Access but not for business-to-business communications.
  • C. The Expressway-C and Expressway-E pair can enable connectivity from the corporate network to the PSTN via a T1/E1 trunk.
  • D. The Expressway-C and Expressway-E pair can interconnect H 323-to-SIP calls for voice.
  • E. Expressway-E provides a VPN entry point for Cisco IP phones with a Cisco AnyConnect client using authentication based on certificates.

Answer: B,D

 

NEW QUESTION 38
Which wildcard must an engineer configure to match a whole domain in SIP route patterns?

  • A. *
  • B. !
  • C. .
  • D. @

Answer: A

 

NEW QUESTION 39

Refer to the exhibit. What is a possible cause of the PRI issue?

  • A. The clock source is incorrect.
  • B. The framing is configured incorrectly.
  • C. The cable is unplugged.
  • D. The controller shut down.

Answer: B

 

NEW QUESTION 40
Given the H.323 gateway configuration and using Cisco best practices, how must the called party transformation pattern be configured to ensure that a proper ISDN type of number is set?

  • A.
  • B.
  • C.
  • D.
  • E.

Answer: D

 

NEW QUESTION 41
What does average rate limiting allow?

  • A. bandwidth up to the Be size
  • B. transmits traffic bursts up to the Bc size
  • C. more traffic than the CIR to be sent when there is available bandwidth
  • D. traffic to burst to the Be size when there is available bandwidth

Answer: D

 

NEW QUESTION 42
You are adding regions in Cisco Unified Communications Manager. Which codec(s) are selected when a call is placed if you set up the max audio bit rate to use 8 kbps?

  • A. G.729
  • B. G.711ulaw and G.711alaw
  • C. G.722
  • D. G.729 and G.711ualw

Answer: A

 

NEW QUESTION 43
What dialed numbers match this Cisco UCM route pattern?
1[23]XX

  • A. 1200 through 1399 only
  • B. 1200 through 1300 only
  • C. 12300 through 12399 only
  • D. 1230 through 1239 only

Answer: A

Explanation:
Section: Call Control

 

NEW QUESTION 44
An engineer with ID378163512 is designing a new dial plan for a customer that has offices in several countries on four continents around the world. This client also want to integrate with a Microsoft Lync backend, Which dial plan type does the engineer recommend?

  • A. SIP URI
  • B. TEHQ
  • C. E.164
  • D. H.323

Answer: C

 

NEW QUESTION 45

Refer to the exhibit. A Cisco UCM user with directory number 4401 dials 5507, and the call is routed to a Cisco Unified Border Element. Which IP address will the call be sent to?

  • A. 10.0.0.2
  • B. 10.0.0.3
  • C. 10.0.0.1
  • D. 10.0.0.4

Answer: D

Explanation:
Section: Infrastructure and Design

 

NEW QUESTION 46
A Cisco TelePresence SX80 suddenly has issues displaying main video to a display over HDMI. Which command can you use from the SX80 admin CLI to check the video output status to the monitor?

  • A. xStatus HDMI Output
  • B. xCommand Video Status
  • C. xConfiguration Video Output
  • D. xStatus Video Output

Answer: C

Explanation:
Section: Infrastructure and Design

 

NEW QUESTION 47
......

Trend for 350-801 pdf dumps before actual exam: https://www.pass4leader.com/Cisco/350-801-exam.html

Real Exam Questions & Answers - Cisco 350-801 Dump is Ready: https://drive.google.com/open?id=1LaeB_27kxiG4Ht_OHRvE86sEBzMOGv-G