Free Huawei H12-323_V2.0 Practice Test & Real Exam Questions

Drag and Drop Question
In the wireless configuration synchronization function, wireless configuration can be divided into two types: public configuration and private configuration. Please match the specific wireless configuration with the configuration type.

Which of the following steps does not belong to the "five-step network planning" of WLAN Planner?

In the stadium hall scene, the floor heights mainly include ordinary areas (3 meters) and high- ceiling areas (greater than 6 meters).
Which of the following descriptions of the network planning solutions for these two areas is wrong?

In WLAN network, which of the following descriptions about Symbol and GI is wrong?

An engineer is setting up a wireless network environment at a customer site. The wireless terminal authentication method uses 802.1X authentication, the authentication point is on the Huawei wireless controller, and the authentication server uses iMasterNCE-Campus. To implement 802.1X functionality, which of the following templates do engineers need to configure on the wireless controller? (Multiple choice)

In a parking lot scenario as shown in the figure, it is recommended that APs be deployed above lanes and also at intersections to ensure continuous signal coverage.

Use WLAN After Planner completes the network planning steps, it can output the network planning report through the "Export Report Function". Which of the following contents can be included in the report? (Multiple choice)

In the VRRP hot backup networking mode, the active and standby WACs establish active and standby backup channels through the () protocol to achieve data synchronization and backup functions for each business module.

In WLAN networks, the spatial direction of the electric field vector in the direction of maximum radiation of the antenna is usually taken as the polarization direction of the electromagnetic wave.
Which of the following descriptions of antenna polarization are correct? (Multiple choice)

The engineer logged into CampuslInsight to inspect the customer's wireless network. By checking the wireless problem analysis (the results are shown in the figure below), it was found that one of the A devices had a non-5 priority access problem.

Which of the following could not be the cause of this problem?

On the premise of ensuring WLAN network coverage, the AP transmit power can be lowered to reduce co-channel interference.

In coverage optimization, if the AP uses an external antenna, in addition to adjusting the AP location, you can also adjust the antenna direction to meet the coverage requirements. Which of the following options are correct regarding antenna direction selection? (Multiple choice)

Which of the following factors should be considered when deploying the AP9330DN indoor distribution solution? (Multiple choice)

After the radio frequency automatic adjustment function is enabled on the wireless controller, changes in the channel and power may cause service interruption of the terminal currently associated with the wireless signal

If all indicators of the AP are always off, it is possible that the indicator light is currently configured to be turned off. It is recommended to configure the undoledoff command on the wireless controller to turn on the indicator light and then reset the indicator light status.