Free HP HP2-T23 Practice Test & Real Exam Questions

Exam Code/Number: HP2-T23
Exam Name/Title: Supporting Industry Standard Server Solutions
Certification Provider: HP
Corresponding Certification: HP ExpertONE Certification

Exam Questions: 109
Updated On: Jun 15, 2026

Question #1

A support engineer needs to add memory to a ProLiant ML350p Gen8 server.
What should the engineer consider when selecting the DDR3 DIMMs to install in this server?

A. Registered DIMMs (RDIMMs) are supported offer larger capacities than UDIMMs, and include address parity protection.

B. Load Reduced DIMMs (LRDIMMs) are supported, use the least power, and have the lowest latencies for the same memory clock speeds

C. Hypercloud DIMMs (HDIMMs) are supported and operate at four DIMMs per channel with all memory channels populated.

D. Unbuffered DIMMs (UDIMMs) are supported and meet low power and large capacity requirements.

Discussion 0

Correct Answer: D Vote an answer

Question #2

A customer placed a service call after installing genuine HP memory from a ProLiant DL380 Gen7 server into a new ProLiant DL380 Gen8 server and receiving a POST message that the memory is not HP Smart Memory.
What caused this to happen?

A. Only Gen8 memory can be detected as Smart Memory.

B. The memory is not in the correct processor Bank.

C. The memory is not authentic HP memory.

D. The memory is defective and is not discovered during POST.

Discussion 0

Correct Answer: A Vote an answer

Question #3

Which statement is correct about the HP iLO Management Engine?

A. Intelligent Provisioning is one of the major features of the iLO Management Engine.

B. The health driver (agent management) is the only tool for HP SIM to collect server information from the iLO Management Engine.

C. It is recharged continuously through a trickle charging process to protect data in a failed server for up to three or four days.

D. The Active Health feature in the iLO Management Engine does not monitor hardware.

Discussion 0

Correct Answer: A Vote an answer

Question #4

How wide must the a data center door be to allow an HP MCS G2 rack to be brought into the data center?

A. 110 cm (3.6 feet)

B. 60 cm (2 feet)

C. 45 cm (1.5 feet)

D. 80 cm (2.5 feet)

Discussion 0

Correct Answer: A Vote an answer

Question #5

In which direction does the air flow through a c7000 enclosure?

A. back to front

B. bottom to top

C. front to back

D. top to bottom

Discussion 0

Correct Answer: C Vote an answer

Question #6

Which statements are correct about HP Systems Insight Manager (HP SIM) 7.0 Agentless Management? (Select two.)

A. Agentless Management is provided by the CPU.

B. HP SIM communicates with the CPU and collects essential data for the operating system.

C. HP SIM communicates with the iLO Management Engine to collect hardware data.

D. The Agentless Management Service runs on the host to provide software information directly to the iLO Management Engine.

Discussion 0

Correct Answer: C,D Vote an answer

Question #7

After you replace the system board in a ProLiantBL460c G8 server blade,the server cannot conned to an external shared storage through the SAS interface. Other similar servers in the same enclosure are in working condition. What should you check to verify that the physical hardware connectivity it connected?

A. External storage power status

B. Server blade port mapping for theIOmodule connectivity to the interconnect module

C. ACU of the server blade for storage status

D. Server bladeiLO tot hardware information detected by the management processor

Discussion 0

Correct Answer: B Vote an answer

Download Free HP HP2-T23 Demo

Simply submit your e-mail address below to get started with our free demo of your HP HP2-T23 exam.