Free Cisco 350-050 Practice Test & Real Exam Questions

Exam Code/Number: 350-050
Exam Name/Title: CCIE Wireless Exam (V2.0)
Certification Provider: Cisco
Corresponding Certification: CCIE

Exam Questions: 315
Updated On: Aug 14, 2026

Question #1

You are designing a wireless guest access solution to be used on a central campus and remote sites, where APs are configured in FlexConnect mode. The guest Internet access service is offered by the domain controller. You want to use the guest anchor feature on the Cisco WLC. Which Cisco WLC type should you consider deploying?

A. A Cisco WLC by itself is not sufficient to support guest anchor and captive portal services.

B. A Cisco 2504 WLC, running Release 7.0.116.0, because guest access is a best-effort service and does not need to support large loads.

C. A Cisco 5508 WLC, running Release 7.0.116.0, deployed as a guest anchor WL

D. Any Cisco WLC.

Discussion 0

Correct Answer: C Vote an answer

Question #2

Refer to the exhibit.

Which DHCP option is shown?

A. 60

B. 150

C. 32

D. 241

E. 43

Discussion 0

Correct Answer: A Vote an answer

Question #3

A network administrator is troubleshooting a problem of a CAPWAP access point that intermittently disconnects from the WLC. The administrator is trying to determine when the problem is happening. UDP port 514 is allowed. What is the best option for successfully gathering comprehensive information about the problem?

A. Configure the CAPWAP AP for buffered logging and level 7. Configure the WLC for syslog and level 7.

B. The CAPWAP AP has no syslog capability but the WLC does have syslog capability. Configure the WLC for syslog and level 1.

C. Configure the CAPWAP AP and the WLC for syslog and level 1.

D. Configure the CAPWAP AP and the WLC for syslog and level 6.

E. Configure a script to log into the WLC to gather logs and save them on a PC, where they can be reviewed daily.

Discussion 0

Correct Answer: D Vote an answer

Question #4

The IT administrator can confirm the air quality and existing non-Wi-Fi interference on the Cisco WLC but cannot find any non-Wi-Fi interference on the Cisco WCS. What are two possible reasons for this issue? (Choose two.)

A. The administrator needs to enable the CleanAir function from the Cisco WCS GUI again.

B. The administrator did not add Cisco MSE to Cisco WCS.

C. The administrator added Cisco MSE to Cisco WCS but forgot to sync Cisco MSE with Cisco WLC and the floor map.

D. The administrator needs to restart Cisco WCS after adding Cisco WLC, to enable the CleanAir function.

Discussion 0

Correct Answer: B,C Vote an answer

Question #5

Which of the below statements is true about Radio Resource Management Neighbor messages? (Choose three.)

A. they are transmitted at maximum power

B. they are transmitted on all serviced channels

C. they are transmitted at minimum power

D. they are transmitted every 60 seconds

E. they are transmitted at the highest data rate

F. they are transmitted at the lowest supported data rate

Discussion 0

Correct Answer: A,D,F Vote an answer

Question #6

You are designing a wireless point-to-point connection between two buildings that are 5 miles (8 km) apart. Which statement is true regarding the design, considering that there is a lake between the two buildings?

A. You do not need to be concerned about multipath, reflection, scattering, or refraction because this is an outdoor design.

B. You need to simplify the design by putting a router on each building because wireless APs or bridges cannot carry 802.1Q traffic across the wireless link.

C. Your concern should be the lake between the two buildings rather than the distance, because the water will absorb the signal.

D. You need to be concerned with the even and odd Fresnel zones because they can result in signal cancellation or amplification.

E. A pair of workgroup bridges will need to be used to bridge Ethernet traffic over the air between buildings.

Discussion 0

Correct Answer: D Vote an answer

Question #7

Refer to the exhibit.

The ACS RADIUS Authentication Report shows the output for a failed client authentication. Which action can resolve this issue?

A. Install the complete ACS certificate CA chain on the client operating system.

B. Re-generate the local ACS certificate, which was issued by an unknown CA.

C. Import the complete client certificate CA chain on the ACS.

D. Re-generate the client certificate, which is expired.

Discussion 0

Correct Answer: C Vote an answer

Question #8

You are troubleshooting a connectivity issue on a Cisco WLC, in which wireless clients occasionally lose their connection. Which two of these infrastructure application services can help you to troubleshoot this issue by using one service to synchronize time on the WLC, and a server that is configured with another service to receive the output of the client debugs from the WLC? (Choose two.)

A. DHCP

B. syslog

C. TFTP

D. NTP

E. TRAPLOG

F. SNMP

G. FTP

Discussion 0

Correct Answer: B,D Vote an answer

Download Free Cisco 350-050 Demo

Simply submit your e-mail address below to get started with our free demo of your Cisco 350-050 exam.