Free Cisco 300-365 Practice Test & Real Exam Questions
A client reports that video is not streaming. The administrator determines the client is connecting at a data rate of 12 Mbps and is trying to stream to a valid multicast address on the network. What three items should the administrator check next to troubleshoot the issue? (Choose three)
Correct Answer: C,E,F
Vote an answer
In a Cisco controller-based wireless network that supports workgroup bridges, what is the maximum amount of wired client connections supported on a workgroup bridge?
Correct Answer: A
Vote an answer
Which feature must be enabled on a WLC to ensure that ARP, DHCP, and data traffic can be forwarded to wired clients located behind non-Cisco workgroup bridges?
Correct Answer: D
Vote an answer
A wireless engineer must design a wireless mesh network for the courtyard at a local university to support a large number ofstudents. Which description of how the engineer designs the mesh network to provide additional capacity is true?
Correct Answer: B
Vote an answer
A network engineer is configuring QoS and sees a DSCPvalue of 40. To which CoS value will this be mapped?
Correct Answer: E
Vote an answer
Which command do you use to ensure that a workgroupbridge can associate and communicate with a non- Cisco AP?
Correct Answer: C
Vote an answer
Scenario:
You have been tasked with setting up a mobility group (Mobility_Test) in a test lab. Thereare two WLCs that you will need to configure (Test1 and Test2). Use the Administrative Workstation to acces the Test1 and Test2 WLCs. Once configured you will need to verify that the mobility group peers are communicating properly.
Mobility Group Name: Mobility_Test
Mobility Group Members: Test1
IP Address: 192.168.1.99
MAC Address: b0:fa:eb:8c:2b:a0
Mobility Group Members: Test2
Ip Address 192.168.1.100
MAC Address: d0:c2:82:e3:aa:20
You have configured mobility group properly when the status of themobility group peers isUP.
TOPOLOGY
VIRTUAL TERMINAL
You have been tasked with setting up a mobility group (Mobility_Test) in a test lab. Thereare two WLCs that you will need to configure (Test1 and Test2). Use the Administrative Workstation to acces the Test1 and Test2 WLCs. Once configured you will need to verify that the mobility group peers are communicating properly.
Mobility Group Name: Mobility_Test
Mobility Group Members: Test1
IP Address: 192.168.1.99
MAC Address: b0:fa:eb:8c:2b:a0
Mobility Group Members: Test2
Ip Address 192.168.1.100
MAC Address: d0:c2:82:e3:aa:20
You have configured mobility group properly when the status of themobility group peers isUP.
TOPOLOGY
VIRTUAL TERMINAL
Correct Answer:
See explanation below
Explanation
Mobility Controllers belong to only one group, and can know several mobility groups On Test 1 WLC
1. Choose Controller> MobilityManagement > Mobility Peer
2. Click New
3. Enter the following details of Test 2:
a) Mobility Member IP
b) Mobility Member Public IP
c) Mobility Member Group Name
d) Multicast IP Address
4. Apply and Save
Similarly log in to Test 2 and enterdetails of Test1
Explanation
Mobility Controllers belong to only one group, and can know several mobility groups On Test 1 WLC
1. Choose Controller> MobilityManagement > Mobility Peer
2. Click New
3. Enter the following details of Test 2:
a) Mobility Member IP
b) Mobility Member Public IP
c) Mobility Member Group Name
d) Multicast IP Address
4. Apply and Save
Similarly log in to Test 2 and enterdetails of Test1
Which impact of co-channel interference in WLANs is true?
Correct Answer: B
Vote an answer
Where must a VLAN tag be present for the client to be placed on a specific interface using Cisco Identity Based Networking?
Correct Answer: D
Vote an answer
A customer has configured a wireless LAN controller and set the 802.11a/n data rates. All rates are enabled where 5.5 Mbps, 11Mbps, and 24 Mbps are set to Mandatory. What will APs send over the 24 Mbps data rate?
Correct Answer: A
Vote an answer
Which RTLS technique uses the nearest position of a client to an AP to track the location of the client?
Correct Answer: C
Vote an answer
Which is the recommended maximum number of hop counts to support data clients on a wireless indoor mesh network?
Correct Answer: B
Vote an answer
Branch wireless users report that they can no longer access services from head office but can access services locally at the site. New wireless users can associate to the wireless while the WAN is down. Which three options (Cisco FlexConnect state, operationmode, and authentication method) are seen in this scenario?
(Choose three.)
(Choose three.)
Correct Answer: A,D,E
Vote an answer
An engineer is reducing the subnet size of the corporate WLAN by segmenting the VLAN intosmaller subnets.
Clients will be assigned a subnet by location. Which type of groups can the engineer user to map the smaller subnets to the corporate WLAN?
Clients will be assigned a subnet by location. Which type of groups can the engineer user to map the smaller subnets to the corporate WLAN?
Correct Answer: B
Vote an answer
