Free Cisco 350-001 Practice Test & Real Exam Questions, Page 2

Question #15

Which two are differences between IGMPv2 and IGMPv3 reports? (Choose two.)

A. All IGMPv3 hosts send reports to destination address 224.0.0.23.

B. IGMPv2 does not support the Leave Group message.

C. Only IGMPv2 reports may contain multiple group state records.

D. IGMPv3 has the ability to include or exclude source lists.

E. All IGMPv3 hosts send reports to destination address 224.0.0.22.

Discussion 0

Correct Answer: D,E Vote an answer

Explanation: Only visible for Pass4Leader members. You can sign-up / login (it's free).

Question #16

Which two statements about SA caching are true? (Choose two.)

A. Caching reduces join latency.

B. Caching allows pacing of MSDP messages.

C. Caching should not be done by an MSDP speaker.

D. Caching is used to update the BGP MDT address family.

Discussion 0

Correct Answer: A,B Vote an answer

Explanation: Only visible for Pass4Leader members. You can sign-up / login (it's free).

Question #17

Which statement is true about TCN propagation?

A. The originator of the TCN immediately floods this information through the network.

B. A TCN is generated and sent to the root bridge.

C. The TCN propagation is a two step process.

D. The root bridge must flood this information throughout the network.

Discussion 0

Correct Answer: B Vote an answer

Explanation: Only visible for Pass4Leader members. You can sign-up / login (it's free).

Question #18

Refer to the exhibit.

There are two sites connected across WAN links. All intersite and intrasite links always have the same routing metric. The network administrator sees only the top routers and links being used by hosts at both LAN A and LAN B.
What would be two suggestions to load-balance the traffic across both WAN links? Choose two.

A. Replace HSRP with VRRP.

B. Make R3 and R8 have lower HSRP priority than R1 and R7.

C. Make HSRP track interfaces between the edge and core routers.

D. Add crossed intrasite links: R1-R4, R2-R3, R5-R8, and R6-R7.

E. Replace HSRP with GLBP.

Discussion 0

Correct Answer: D,E Vote an answer

Explanation: Only visible for Pass4Leader members. You can sign-up / login (it's free).

Question #19

Refer to the exhibit.

Cisco 350-001 Exam
While performing an internal audit of your network, you come across this configuration in all of your routers. Which three statements about this configuration are true? (Choose three.)

A. The Event Manager applet is configured incorrectly.

B. The IP SNMP process is monitored every 10 minutes.

C. A publish event is sent to well-known user 798 with an SNMP trap message.

D. When CPU process exceeds 50%, an event is generated.

E. SNMP trap type 50 messages are sent to the event managers.

F. The IP SNMP process is monitored every 10 seconds.

Discussion 0

Correct Answer: C,D,F Vote an answer

Question #20

DRAG DROP

Discussion 0

Correct Answer:

Explanation:

Cisco 350-001 Exam

Question #21

Refer to the exhibit.

This is an MPLS VPN network with OSPF as the PE-CE routing protocol. Which statement is correct?

A. The routing inside the VPN RED can be enabled by configuring virtual links between the PE routers.

B. The routing inside the VPN RED will work without any special OSPF configuration.

C. The routing inside the VPN RED will never work correctly.

D. The routing inside the VPN RED will work if the PE routers have a full mesh of sham-links configured for VRF RED.

E. The routing inside the VPN RED can be enabled by configuring area 0 inside the VRF on the PE routers.

Discussion 0

Correct Answer: B Vote an answer

Explanation: Only visible for Pass4Leader members. You can sign-up / login (it's free).

Question #22

Refer to the exhibit.

Cisco 350-001 Exam

Cisco 350-001 Exam
R2 and R3 are routers connected using Ethernet services from a service provider and can receive pings from each other. OSPF is configured as the routing protocol but adjacency is not happening. According to the output of the show commands in the exhibit, what could be the most likely cause of the problem?

A. OSPF cost does not match on both interfaces.

B. Ethernet interfaces were configured as point-to-point.

C. Configured bandwidths do not match on both interfaces.

D. Process IDs are not matching.

E. Broadcasts and multicast are not being propagated over the Ethernet services.

Discussion 0

Correct Answer: E Vote an answer

Explanation: Only visible for Pass4Leader members. You can sign-up / login (it's free).

Question #23

Which two IPv6 address pairs can be assigned on a point-to-point link with a /125 mask? (Choose two.)

A. 2001:DB8::1 and 2001:DB8::2

B. 2001:DB8::10 and 2001:DB8::17

C. 2001:DB8::1 and 2001:DB8::18

D. 2001:DB8::9 and 2001:DB8::10

Discussion 0

Correct Answer: A,D Vote an answer

Explanation: Only visible for Pass4Leader members. You can sign-up / login (it's free).

Question #24

The OSPF RFC 3623 Graceful Restart feature allows you to configure IETF NSF in ultivendor networks. When using OSPF Graceful Restart, which mechanism is used to continue forwarding packets during a switchover?

A. UDP forwarding

B. Hardware-based forwarding

C. Layer 2 Forwarding

D. Reverse Path Forwarding

Discussion 0

Correct Answer: B Vote an answer

Explanation: Only visible for Pass4Leader members. You can sign-up / login (it's free).

Question #25

Refer to the exhibit.

Your network is primarily an OSPF network, but there are points of redistribution from other routing protocols into your network. No route filtering has been implemented. Taking into account the output from the show ip ospf database command in the exhibit, which of these statements is true?

A. R101 is an ASBR

B. R101 is in Area 1, and Area 1 is an OSPF stub area

C. R101 is in Area 1, and Area 1 is a standard OSPF area

D. R101 is in Area 1, and Area 1 is an OSPF not-so-stubby area

E. R101 is an ABR for Area 0 and Area 1

Discussion 0

Correct Answer: C Vote an answer

Question #26

Refer to the exhibit.

Cisco 350-001 Exam
What effect will the as-path filter command that is configured on R4 create BGP routing table?

A. It will have routes 30.30.1.0/24 and 200.200.6.6/32.

B. It will have routes 40.40.1.0/24 and 200.200.6.6/32.

C. It will have all three routes on the R4 BGP routing table

D. It will have only the route 30.30.1.0/24.

E. It will have routes 30.30.1.0/24 and 40.40.1.0/24.

F. It will have none of the three routes on the R4 BGP routing table.

Discussion 0

Correct Answer: F Vote an answer

Explanation: Only visible for Pass4Leader members. You can sign-up / login (it's free).

Question #27

Your company is researching a new application that runs over IPv6, but part of it must still have IPv4 support. Your company uses a traditional IPv4 network. Your plan is not to run IPv6 over the whole network, but to segment parts of the network or even to operate simultaneously with IPv6 and IPv4. You must make a brief presentation about IPv6 technology to the board of technical directors. Which three of these items could be part of your presentation? (Choose three.)

A. Tunnel IPv4 over IPv6 to connect far-end IPv4 networks.

B. Explain why configuring IPv4 and IPv6 at the same time over the same LAN interface is not possible.

C. Explain why configuring IPv4 and IPv6 at the same time over the same LAN interface is possible.

D. What is the meaning of EUI-64 and how does it work?

E. Tunnel IPv6 over IPv4 to connect far-end IPv6 networks.

Discussion 0

Correct Answer: C,D,E Vote an answer

Explanation: Only visible for Pass4Leader members. You can sign-up / login (it's free).

Question #28

Refer to the exhibit.

Which option is correct?

A. This configuration is not valid.

B. The user can use Telnet to any interface on the device as long as the input interface for Telnet is FastEthernet 0/0.

C. The user can use Telnet from the router only if the Telnet is sourced from FastEthernet 0/0.

D. Telnet access is not allowed on the router.

Discussion 0

Correct Answer: B Vote an answer

Explanation: Only visible for Pass4Leader members. You can sign-up / login (it's free).

Free Cisco 350-001 Practice Test & Real Exam Questions

Download Free Cisco 350-001 Demo