Free Cisco 300-110 Practice Test & Real Exam Questions

A wireless network consists of two IOS XE controllers installed in a data center, 9100 series APs, and a corporate and a guest WLAN. The customer must have a high availability pair of two Cisco WLCs for the client SSO. Which two design approaches must the engineer take to meet the requirement? (Choose two.)

A customer wants a network engineer to design a Cisco wireless solution that will have redundancy through SSO and LAG. APs in the executive office must reassociate to the WLC as soon as possible in the event of a failure. The WLCs are located in a remote data center. The head office uses a WAN for connectivity with the data center. Which priority must be incorporated in the design to be assigned to the executive APs?

During a site survey for a new wireless deployment in a multifloor office building, an engineer must identify sources of interference and ensure optimal AP placement for 5 GHz coverage. While walking the site with a spectrum analyzer, the engineer notices periodic spikes in the noise floor on several channels and inconsistent signal strengths reported by the survey tool, despite visually unobstructed paths. Which action must the engineer take next to accurately assess and mitigate the Layer 1 interference?

An enterprise network is deploying two Cisco Catalyst 9800 WLCs in a data center to ensure uninterrupted wireless services for a campus with thousands of users. The IT management requests a design that enables seamless failover without client reauthentication or loss of connectivity if one controller fails. Ease of configuration and ongoing management are high priorities. The controllers will be connected via a high-speed LAN segment, and both must support full active-passive redundancy for all managed APs. Which design approach meets the requirements?

The wireless team must configure a new voice SSID for optimized roaming across multiple WLCs with Cisco
8821 phones. Which two settings accomplish this goal? (Choose two.)

An engineer in a branch office that does not have a wired backhaul must ensure that local clients can be switched locally and authenticated centrally. In which mode must the AP be configured?

A company is upgrading its wireless infrastructure and is in a state of transition. Some parts of the company ' s building still run on the legacy WLC. The new WLC is not located at the same site as the legacy WLC. The company requires seamless client inter-controller roaming between the new WLC and the legacy WLC, with no disruptions. Both WLCs are separated by firewalls. Which troubleshooting command validates that the mobility control packets between the WLCs can be sent and received?

A small customer has a legacy autonomous mode Wi-Fi deployment that provides a low-density and low- capacity service. The customer wants to update and replace this deployment with the latest Wi-Fi technology but has a fixed budget that will pay only to replace the APs. Which architectural controller deployment model suits this requirement?

An engineer is using Ekahau Site Survey to create a WLAN plan for a warehouse. The plan is to use patch antennas. Which setting is adjusted when simulated APs are placed on the map?

A university wants to deploy a high density of APs in an area where a high number of users congregate.
Which functionality allows the university to optimize the RF settings for APs that operate in different environments or coverage zones?