Free CheckPoint 156-215-75 Practice Test & Real Exam Questions

Match each of the following command to their correct function. Each command has one function only listed.

Checkpoint 156-215.75 : Practice Test

Many companies have defined more than one administrator. To increase security, only one administrator should be able to install a Rule Base on a specific Firewall. How do you configure this?

You are evaluating the configuration of a mesh VPN Community used to create a site-tosite VPN. This graphic displays the VPN properties in this mesh Community.

Which of the following would be the most valid conclusion?

When doing a Stand-Alone Installation, you would install the Security Management Server with which other Check Point architecture component?

When troubleshooting NAT entries in SmartView Tracker, which column do we need to check to view the NAT'd source port when using source NAT?

Your network is experiencing connectivity problems and you want to verify if routing problems are present. You need to disable the firewall process but still allow routing to pass through the Gateway running on an IP Appliance running IPSO. What command do you need to run after stopping the firewall service?

Which item below in a Security Policy would be enforced first?

How do you use SmartView Monitor to compile traffic statistics for your company's Internet
activity during production hours?

When you hide a rule in a Rule Base, how can you then disable the rule?

An Administrator without access to SmartDashboard installed a new IPSO-based R75 Security Gateway over the weekend. He e-mailed you the SIC activation key. You want to confirm communication between the Security Gateway and the Management Server by installing the Policy. What might prevent you from installing the Policy?

To monitor all traffic between a network and the Internet on a SecurePlatform Gateway, what is the BEST utility to use?

John is the Security Administrator in his company. He installs a new R75 Security Management Server and a new R75 Gateway. He now wants to establish SIC between them. After entering the activation key, the message "Trust established" is displayed in SmartDashboard, but SIC still does not seem to work because the policy won't install and interface fetching still does not work. What might be a reason for this?

One of your licenses is set for an IP address no longer in use. What happens to this license during the license-upgrade process?

Which Security Servers can perform authentication tasks, but CANNOT perform content security tasks?